ECG KOKUSAI Co., Ltd.

Various measurement hardware and inspection equipment|Impulse winding tester

Products

Coil tester

Impulse Winding Tester DWX Series
DWX -10LI

Inductance Test Range (10μH~0.1μH)
High voltage impulse can be applied, and layer short
in the winding of coil
Corona discharge test can be done

Power inductor for liquid crystals for LED back lights
DC-DC converters for choke coil etc.
Ideal for the insulation test of small size and a thin coil inductor!

Specification

  DWX -10LI
Applied Voltage, Step, and Energy
At 1 k Ohm Resistive Load
0.2kV~5.0kV 0.1kV step Maximum 5J(Joule)
Inductance Test Range 10μH~0.1μH grade
Sampling Speed 8 bit / 10 nano-sec. (100MHz)
Sampling Memory 8192-Byte
Sampling Range(WIDTH) -4、-3、-2、-1、0、2、3、4、5 10range
(0 is compatible with DW series.)
Examination input circuit (Impedance ) Resistance division (5Mohm)
Screen Display Resolution
Waveform Display Range
640x480(VGA)、8.4inch TFT color liquid crystal, 4 color displays
512x256
The judgment method Master Waveform Comparison , Detection by Area Size Comparison,
and Corona Discharge
Master waveform capacity   Main part
Extension
196 models (14 models/(14 pages))
700 kinds according to Compact Flash Memory. (14 models/50 pages)
External Interface Parallel I/O(Start、Reset、OK、NG、Busy、Master No. etc.)
Accessories Test Cable(3PAdopter), Operation manual
and an examination results
document, Compact Flash Memory, Parallel I/O Connector.
Environmental conditions 0℃~40℃ Power supply voltage:100V/115V/220V/240V
(It is setup during shipment)
Dimension(Excluding Handle)・Weight 345(W)x373(H)x370(D) 約18Kg