Coil tester
Impulse Winding Tester DWX Series
WT-1303
Features
By comparing the two coils, the registration of the master waveform is not required.
It is ideal for impulse test in small lot production of goods.
For difficult operation is not necessary, it can be tested intuitively.
Ideal for customers using traditional analog impulse testing machine.
Possible testing of low-inductance coil.
Performance
| WT-1303 | |
|---|---|
| Use | General coil component General |
| Inductance range | 10μH～100mH |
| The maximum output voltage (no load) | 3000V |
| Maximum applied voltage (standard) | 1000V when 10μH |
| Waveform sampling resolution | 100MHz equivalent |
| The minimum test time (during one pulse application) |
200ms |
| Judgment function | Comparator (current difference) |
| Test circuit | 2 terminal |
| Test cable length range | Recommended 1.6m (up to 3m) |
| Partial discharge test support | Parallel I / O (Start, Reset, OK, NG, Busy, MasterNo., Etc.) |
| Partial discharge test support | Improper |
| External I / O control signal | STRAT/OK/NG |
| Dimensions (excluding handle and rubber feet) |
430(W)×200(H)×470(D) |
| Power-supply voltage | AC100 / 115/220/240 ± 5% switchtable |
