Direction of rotation tester
The direction of rotation tester RDT-308 applies a 3-phase or single-phase current to a stator coil and measures the direction of rotation, distribution and variation of the magnetic flux generated by the current using a detector (detection sensor) installed in the stator coil.
The system supports stator coils with up to 16 poles, and can also test 12 / 8 / 6 / 4 / 2 poles when a 16-pole detector is used. A full range of functions such as automatic pole number detection, automatic gain and overcurrent protection are also available.
Test mechanism
Test mode 1 Rotation direction inspection
The waveforms of multiple magnetic fluxes detected by the detector are combined into two waveforms, phase A and phase B, and the overall direction of rotation and intensity are determined from the phase difference and amplitude.
Test mode 2 Inspection of phase difference and magnetic field strength by magnetic field distribution
Detects abnormalities in all magnetic fluxes and magnetic flux distributions measured by the multiple sensor coils built into the detector. Partial magnetic flux disturbances can be captured even when the overall direction of rotation is normal, leading to the detection of abnormalities in windings and connections. Although the detector must be positioned in the centre of the stator bore, more accurate testing can be carried out.
| Test item | Test mode 1 | Direction of rotation test (CW/CCW) |
|---|---|---|
| Test mode 2 | Magnetic field distribution test (phase difference/magnetic field strength) | |
| Excitation voltage | Phase type | 3-phase / single-phase |
| Output waveform | 3-phase / 2-phase Sine wave output | |
| Frequency | 5kHz | |
| Excitation voltage (Setting range) | Phase 5Vp-p (100 steps) | |
| Max. applied current | 500mA | |
| Detection | Sensitivity Range | 10 steps＋Auto setting range mode |
| Protection functions | Overcurrent protection | |
| General | Power consumption | 100 - 240VAC ±5% 50/60Hz 40VA or less |
| Environment | Temperature range5℃-40℃ Humid range20%-80% | |
| Communication | SIGNAL IO / RS-232C | |
| Dimensions/Weights | 192(W)×95(H)×235(D) 1.8Kg | |
| Accessories | Power cable (3m) 1 unit 3P-2P conversion adapter 1 unit Diteotor Cable（1.5m) 1 unit Excitation signal cable (1.5m) 1 unit Normal Ditector Coil 1 unit Manual 1unit Spare Fuse（1A） 1unit | |
| Sold separately | ※1 Detector ※1 Detector cable 1.5 m |
|
※1 Detectors should be ordered separately after selecting the model that matches the test object from the compatibility table below.
