Inductor tester
Impulse winding tester for power inductor
DWX-10LI
Impulse Winding Test Device for SUPER Low Inductance
Power inductor for liquid crystals for LED back lights
ＤＣ－ＤＣ converters for choke coil etc.
Ideal for the insulation test of small size and a thin coil inductor!
Specification
| DWX -10LI | ||
|---|---|---|
| Applied Voltage, Step, and Energy At 1 k Ohm Resistive Load |
0.2kV～5.0kV 0.1kV step Maximum 5J(Joule) | |
| Inductance Test Range | 10μH～0.1μH grade | |
| Sampling Speed | 8 bit / 10 nano-sec. (100MHz) | |
| Sampling Memory | 8192-Byte | |
| Sampling Range（WIDTH） | -4、-3、-2、-1、0、2、3、4、5 10range （0 is compatible with DW series.） |
|
| Examination input circuit (Impedance ) | Resistance division (5Mohm) | |
| Screen Display Resolution Waveform Display Range |
640x480(VGA)、8.4inch TFT color liquid crystal, 4 color displays 512x256 |
|
| The judgment method | Master Waveform Comparison , Detection by Area Size Comparison, and Corona Discharge |
|
| Master waveform capacity | Main part Extension |
196 models (14 models/(14 pages)) 700 kinds according to Compact Flash Memory. (14 models/50 pages) |
| External Interface | Parallel I/O(Start､Reset､OK､NG､Busy､Master No. etc.) | |
| Accessories | Test Cable（3PAdopter）, Operation manual and an examination results document, Parallel I/O Connector. |
|
| Environmental conditions | 0℃～40℃ Power supply voltage：100V/115V/220V/240V (It is setup during shipment) |
|
| Dimension(Excluding Handle)･Weight | 345(W)x373(H)x370(D) 約18Kg | |
